P27.50-2208-09
1 | Drive shaft | 5 | Needle bearing | 8 | Planetary gear set 1 | ||
2 | Sealing rings | 6 | Needle bearing | 9 | B08 multidisk brake | ||
3 | Sealing rings | 7 | Snap ring | 10 | Multiplate clutch K81 | ||
4 | Sleeve |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Notes on automatic transmission | |||
| Remove/install | ||
1 | Remove planetary gear set 2 and multiplate clutch K38 with ring gear. | ||
2 | Remove drive shaft (1). | ||
3 | Replace sealing rings (2, 3). | | |
Installation: Slide sealing rings (2, 3) onto sleeve (4), mount sleeve (4) onto drive shaft (1) and carefully remove sealing rings (2, 3) from drive shaft (1). | |||
Set of sleeves | |||
4 | Check needle bearings (5, 6) for damage. | If a needle bearing is damaged, | |
| |||
replace corresponding needle bearing. | |||
5 | Remove snap ring (7). | ||
6 | Remove planetary gear set 1 (8) with multidisk brake B08 (9). | ||
7 | Remove multidisk brake B08 (9) from planetary gear set 1 (8) and check for damage. | ||
Pliers | |||
If the multidisk brake B08 (9) is damaged, | |||
| |||
replace multidisk brake B08 (9). | |||
8 | Remove multiplate clutch K81 (10) and check for damage. | ||
If the multiplate clutch K81 (10) is damaged, | |||
| |||
replace multiplate clutch K81 (10). | |||
9 | Install in the reverse order | ||
Finishing activity | |||
10 | Measure end play of drive shaft (1) and adjust, if necessary. | ||
Device | |||
Parallel support |
000 589 52 37 00
Pliers
725 589 01 14 00
Set of sleeves
725 589 00 31 00
Device
168 589 03 21 00
Parallel support