S27.40-4510-79
Shown on removed transmission |
1 | Adapter housing | 3 | Output flange | 5 | Transmission housing | ||
2 | Collar nut | 4 | Radial shaft sealing ring |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | General information on repair work on transmission | ||
| Remove | ||
1 | Shift transmission in to position "P". | ||
2 | Remove adapter housing (1). | ||
3 | Unscrew collar nut (2). | Socket wrench bit | |
4 | Remove output flange (3). | Puller, two-arm | |
5 | Use suitable tool to pry radial shaft sealing ring (4) out of transmission (5). | | |
| Check | ||
6 | Check seating of radial shaft sealing ring (4) for damage. | If damage is visible, | |
| |||
Replace transmission housing (5). | |||
| Install | ||
7 | Coat new radial shaft sealing ring (4) with transmission oil. | ||
| Automatic transmission fluids (ATF) (specification 236.15) | ||
8 | Using drift, press new radial shaft sealing ring (4) into transmission housing (5) until drift makes contact with transmission housing (5). | Drift | |
9 | Install output flange (3). | ||
10 | Tighten new collar nut (2). | Collar nut, output flange to output shaft | |
Socket wrench bit | |||
11 | Install adapter housing (1). | ||
12 | Correct transmission oil level. | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
13 | Perform engine test run and check transmission for leak tightness and proper operation. |
140 589 12 15 00
Drift
000 589 88 33 00
Puller, two-arm
126 589 02 09 00
Socket wrench bit