AR26.60-W-7100E | Remove/install hydraulic gate cylinder | 28.4.08 |
TRANSMISSION 715.5 in MODEL 930, 932, 933, 934, 940, 942, 943, 944
with CODE (GS3) "Hydraulic" gearshift
with CODE (IY2) Hydraulic fluid as per sheet 345.0
W26.60-1274-06
Illustrated on model 930
1 Gate shift cylinder
2 Bolts
3 Retaining clips
4 Hydraulic lines
5 Clamping pieces (only on model 930, 932, 933, 934)
6 Piston rod
7 O-ring
8 Shift shaft driver
9 O-ring
| Remove/install | ||
| Notes on hydraulic fluid as per Specification, Sheet 345.0 | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
1 | Tilt cab | Only on vehicles with code (F04) cab L (long) or with code (F15) MEGASPACE cab. | |
| Notes on tilting the cab | ||
2 | Remove cover above transmission | ||
3 | Detach clamping pieces (5) from the hydraulic lines (4) | Only for models 930, 932, 933, 934. | |
| |||
4 | Pull out retaining clamps (3) and disconnect hydraulic lines (4) from gate shift cylinder (1) | Collect fluid which runs out and seal hydraulic lines (4) with suitable plugs. | |
Installation: install new O-rings (9). | |||
5 | Unscrew bolts (2) on gate shift cylinder (1) | | |
6 | Detach gate shift cylinder (1) | Pull out gate shift cylinder (1) up to the stop, turn towards "11 o'clock" and remove. | |
Installation: Replace O-ring (7). Installation: Before inserting the piston rod (6) in the shift shaft driver (8), pull out the piston rod (6) of the gate shift cylinder (1) completely. | |||
7 | Install in the reverse order | ||
8 | Bleeding air from hydraulic-pneumatic shift-control mechanism (HPS) | Model 930, 932, 933, 934 | |
Model 940, 942, 943, 944 right-hand drive vehicles; | |||
Model 940, 942, 943, 944 left-hand drive vehicles |
Shift mechanism