AR26.60-W-7100C | Remove/install hydraulic gate cylinder | 1.12.03 |
TRANSMISSION 715.570 in MODELS 950.5 /6, 952.5 /6, 953.6, 954.5 with CODE (GS3) "Hydraulic" transmission shift
TRANSMISSION 715.570 in MODEL 970, 972, 974, 976 with CODE (GS3) Hydraulic gearshift
W26.60-1144-12
1 Gate shift cylinder
2 Piston rod
3 Sealing ring
4 Hydraulic line
5 Hydraulic line
6 Shift shaft driver
| Remove/install | ||
Danger! | Risk of injury caused by being caught or pinched as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
1 | Tilt cab | ||
| Notes on tilting the cab | ||
2 | Detach hydraulic lines (4 and 5) from shift cylinder for gate (1) | Identify installation position of hydraulic lines (4 and 5). Collect fluid which runs out. | |
| |||
| Notes on hydraulic fluid as per specification sheet 345.0 | ||
3 | Detach gate shift cylinder (1) | Press back compressed-air line slightly. Pull out shift cylinder for gate (1) up to the stop, move towards "11 o'clock" and remove | |
Installation: Before inserting the piston rod (2) in the shift shaft driver (6), pull out the piston rod (2) of the shift cylinder for gate (1) completely. Replace seal (3). | |||
| |||
4 | Install in the reverse order | ||
5 | Bleeding air from hydraulic-pneumatic shift-control mechanism (HPS) | Model 950, 952, 953, 954 | |
Models 970, 972. 974. 976 | |||
6 | Check leaktightness of gearshift |
Gearshift system