S26.60-4555-09
1 | Bracket | 2b | Nut | A | Shift cable | ||
2a | Nut | 3 | Cover | B | Shift cable |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Remove gearshift lever with bearing bracket. | ||
2.1 | Remove engine compartment lining. | Except code Y1J (Underguard) | |
Only remove rear and center engine compartment lining. | |||
2.2 | Remove underbody protection. | With code Y1J (Underguard) | |
Remove only rear and center technical underbody protection. | |||
3.1 | Remove diesel particulate filter. | Except code MT2 (emissions class Euro 6d-TEMP N1 GR.III/N2) | |
3.2 | Remove exhaust gas aftertreatment unit. | With code MT2 (emissions class Euro 6d-TEMP N1 GR.III/N2) | |
4 | Detach shift cables (A, B) from transmission. | ||
5 | Remove nuts (2a, 2b) from cover (3). | ||
6 | Pull out shift cables (A, B) downward. | ||
| Install | ||
7 | Install shift cables (A, B) with cover (3). | ||
8 | Attach nuts (2a, 2b) to cover (3). | Nut, cover to firewall | |
9 | Attach shift cables (A, B) to transmission. | ||
Long-life grease | |||
10.1 | Install diesel particulate filter. | Except code MT2 (emissions class Euro 6d-TEMP N1 GR.III/N2) | |
10.2 | Install exhaust gas aftertreatment unit. | With code MT2 (emissions class Euro 6d-TEMP N1 GR.III/N2) | |
11.1 | Install engine compartment lining. | Except code Y1J (Underguard) | |
11.2 | Install underbody protection. | With code Y1J (Underguard) | |
12 | Install gearshift lever with bearing bracket. |