D26.60-1217-07
1 | Screw | 4 | Retaining plate | |
2 | Cover | 5 | Shift cable passage | |
3 | Screw | 6 | Gearshift lever with bearing bracket |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Raise vehicle. | ||
2 | Remove shift cables from transmission. | ||
Long-life grease | |||
3 | Remove left door sill trim. |
| |
4 | Turn over floor covering on left side. | Turn over floor covering far enough until left cover (2) can be removed. | |
5 | Unscrew bolt (1). | ||
6 | Remove trim (2). | ||
7 | Remove bolts (3), remove retaining plate (4) and shift cable passage (5) from floor panel. | Installation: Check shift cable passage (5) for damage and replace if necessary. | |
Bolt, shift cable opening to floor panel | |||
8 | Remove cover from instrument panel middle section. | ||
Installation: Only clip in gearshift lever boot after adjusting the shift cables. | |||
9 | Remove gearshift lever with bearing bracket (6). | ||
Screw/bolt, bearing bracket to mounting bracket | |||
10 | Remove shift cables from gearshift lever with bearing bracket (6). | ||
Long-life grease | |||
11 | Install in the reverse order. | ||
12 | Adjust shift cables. |