1 | Seal |
2 | Shim |
3 | Compressed-air line |
4 | Power take-off 2 |
5 | Seal |
6 | Threaded pins |
7 | Bearing housing (with output flange) |
8 | Nut |
9 | Hydraulic pump |
S79 | Power take-off 2 indicator switch |
W26.45-1167-06
| Notes on compressed air connection systems | ||
| Remove/install | ||
1 | Detach drive shaft from bearing housing (7) | Only on power take-off without hydraulic pump. | |
Propeller shaft to power take-off | |||
2 | Disconnect electrical connector | ||
3 | Detach compressed-air line (3) | ||
4.1 | Remove bearing housing (7) | On power take-off without hydraulic pump | |
Collect oil which runs out in a suitable container. | |||
Installation: Clean sealing surfaces and replace seal (5). | |||
Nut, second power take-off to power take-off | |||
4.2 | Detach hydraulic pump (9) | On power take-off with hydraulic pump | |
Collect oil which runs out in a suitable container. | |||
Installation: Clean sealing surfaces and replace seal (5). | |||
5 | Remove power take-off 2 (4) and shim (2) | Installation: Clean the sealing surfaces and install a new seal (1). | |
6 | Install in the reverse order | ||
7 | Check transmission oil level, adjust to correct level if necessary | ||
| Transmission 715.320/350/370/380/500/507/510/513/515/525/540/561 Transmission 715.520 without code G02 (Torque converter clutch (WSK)) Transmission 715.570 except in model 949 | ||
| Transmission 715.520 with code G02 (Torque converter clutch (WSK)) | ||
| Transmission 715.570 in model 949 |