1 | Power take-off 1 |
2 | Seal |
3 | Hydraulic pump 1 |
4 | Hydraulic pump 2 |
5 | Power take-off 2 |
6 | Seal |
W26.45-1176-11
Danger ! | Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure.Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | |
| Remove/install | ||
1 | Separate hydraulic lines at hydraulic pump 1 (3) and hydraulic pump 2 (4) | Collect hydraulic fluid which flows out in a suitable vessel. | |
2 | Remove hydraulic pump 2 (4) and power take-off 2 (5) from power take-off 1 (1) | Collect oil which runs out in a suitable container. | |
Installation: Clean sealing surfaces and replace seals (6). | |||
Nut, hydraulic pump to power take-off | |||
3 | Detach hydraulic pump 1 (3) from power take-off 1 (1) | Collect oil which runs out in a suitable container. | |
Installation: Clean sealing surfaces and replace seal (2). | |||
Nut, hydraulic pump to power take-off | |||
4 | Install in the reverse order | ||
5 | Check hydraulic fluid level in oil reservoir, correct if necessary | Note operation and maintenance procedures from each manufacturer. | |
6 | Check transmission oil level, adjust to correct level if necessary | ||
| Transmission 715.320/350/370/380/500/507/510/513/515/525/540/561 Transmission 715.520 without code G02 (Torque converter clutch (WSK)) Transmission 715.570 except in model 949 | ||
| Transmission 715.520 with code G02 (Torque converter clutch (WSK)) | ||
| Transmission 715.570 in model 949 |