W26.45-1335-09
1 | Power take-off 123 | 4 | Drive shaft | 8 | Electrical connector (power take-off 1 indicator switch (S2)) | ||
2 | Power take-off 124 | 5 | Oil pump end cover | 9 | Electrical connector (power take-off 1 solenoid valve (Y8)) | ||
3 | Seal | 7 | Compressed-air line |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on self-locking nuts and bolts | ||
Notes on compressed air connection systems | |||
| Remove/install | ||
1 | Depressurize compressed-air system. | See information from body manufacturer. | |
2 | Drain fluid from transmission. | ||
| |||
3 | Detach output flange from transmission. |
| |
Transmission 715.536 in model 800.1 | |||
Transmission 715.536 in model 800.2/3 | |||
Transmission 715.356/366 | |||
4 | Remove power take-off 2. | Only if power take-off 124-11b or 124-1c is installed. | |
5.1 | Detach propeller shaft from power take-off 123 (1) or power take-off 124 (2). | For power take-off with propeller shaft | |
Propeller shaft to power take-off | |||
5.2 | Remove hydraulic pump. | On power take-off with hydraulic pump | |
Do not separate hydraulic lines if possible, collect hydraulic fluid if necessary. | |||
6 | Disconnect electrical connectors (8, 9) from power take-off 1 indicator switch (S2) and power take-off 1 solenoid valve (Y8). | Mark installation location of electrical connectors (8, 9). | |
Installation: Observe marking for electrical connection (8, 9). | |||
7 | Detach compressed-air line (7) from solenoid valve. | Installation: Replace O-rings. | |
8 | Remove power take-off 123 (1) or power take-off 124 (2). | Installation: Replace seal (3). | |
Bolt, power take-off to transmission | |||
9 | Remove drive shaft (4). | ||
10 | Remove oil pump cap (5). | Only when exchanging the transmission or retrofitting a power take-off. | |
11 | Install in the reverse order. |