1 | Oil pump end cover |
2 | Drive shaft |
3 | Ball bearing |
4 | Retaining ring |
5 | Centering ring |
6 | Seal |
7 | Power take-off |
8 | Electrical connector (power take-off 1 indicator switch (S2)) |
9 | Compressed-air line |
10 | Electrical connector (power take-off 1 solenoid valve (Y8)) |
W26.45-1340-06
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on self-locking nuts and bolts | ||
Notes on compressed air connection systems | |||
| Remove/install | ||
1 | Depressurize compressed-air system. | See information from body manufacturer. | |
2 | Drain fluid from transmission. | ||
| |||
3 | Detach output flange from transmission. |
| |
Transmission 715.536 in model 800.1 | |||
Transmission 715.536 in model 800.2/3 | |||
Transmission 715.356/366 | |||
4.1 | Detach propeller shaft from power take-off (7). | For power take-off with propeller shaft | |
Propeller shaft to power take-off | |||
4.2 | Remove hydraulic pump. | On power take-off with hydraulic pump | |
Do not separate hydraulic lines if possible, collect hydraulic fluid if necessary. | |||
5 | Detach compressed-air line (9) from power take-off (7). | Installation: Replace O-rings. | |
6 | Disconnect electrical connector (10) from power take-off 1 solenoid valve (Y8). | Mark the installation location of the electrical connector (10). | |
Installation: Observe the marking for the electrical connector (10). | |||
7 | Disconnect electrical connector (8) from power take-off 1 indicator switch (S2). | Mark the installation location of the electrical connection (8). | |
Installation: Note the marking for the electrical connection (8). | |||
8 | Remove power take-off (7). | Installation: Replace seal (6). | |
Screw/bolt, power take-off to transmission | |||
9 | Remove drive shaft (2) together with ball bearing (3) and centering ring (5). | ||
10 | Remove oil pump cap (1). | Only when exchanging the transmission or retrofitting a power take-off. | |
| Check | ||
11 | Check drive shaft (2) and ball bearing (3) for wear | In the event of a problem, | |
| |||
Replace drive shaft (2) or ball bearing (3). | |||
12 | Install in the reverse order. |