Remove/install drive shaft radial shaft sealing ring

AR26.40-D-0335SD

17.6.11

TRANSMISSION 711.651 in MODEL 906 with ENGINE 271.951, 646.984 /985 /986 /989 /990

TRANSMISSION 711.660 in MODEL 906 with ENGINE 642.992, 646.984 /985 /986 /989 /990

TRANSMISSION 711.670 in MODEL 204 with ENGINE 642, 651

TRANSMISSION 711.680 in MODEL 906

TRANSMISSION 711.685 in MODEL 906

TRANSMISSION 711.670 in MODEL 207 with ENGINE 651

TRANSMISSION 711.680 in MODEL 900 with ENGINE 651.955

D26.40-1156-01

1 Radial shaft seal

 	Remove/install
1	Remove transmission	Model 204 with transmission 711.67	AR26.10-P-0020SA
		Model 207 with transmission 711.67	AR26.10-P-0020CWA
		Model 900 with transmission 711.680 Model 906 with transmission 711.680/685	AR26.10-D-0020H
		Model 906 with transmission 711.65 and engine 271	AR26.10-D-0020NG
		Model 906 with transmission 711.65 and engine 646 or with transmission 711.66 and engine 642, 646	AR26.10-D-0020G
2	Fasten transmission on assembly stand		AR26.10-D-0036A
3	Remove central clutch release bearing	Model 900, 906	AR25.20-D-0180SD
		Model 204, 207	AR26.40-P-0345CW
4	Pry radial shaft sealing ring (1) out of its seat	 Do not attach lever between radial shaft sealing ring (1) and seat. If the seat is damaged, the front section of the transmission housing must be replaced.
		 Installation: Replace radial shaft seal (1). Clean seat of radial shaft sealing ring (1) and coat sealing lip with transmission oil before installing
		 Drift	*711589161500
	Gear oils (Sheet 235.10)	Sheet 235.10	BB00.40-P-0235-10A
5	Install in the reverse order

Drift

711 589 16 15 00