Check/correct transmission oil level

AR26.00-W-0100G

18.09.2015

Transmission	715.5 in model 930, 932, 934 with engine 541.9
	with code G02 (Torque converter clutch (WSK))
Transmission	715.5 in model 930, 932, 934 with engine 542.9
	with code G02 (Torque converter clutch (WSK))

W26.00-1008-71


1	Check screw


	2	Oil filler plug

W26.00-1009-71

	Check
1	Check adjusted oil quality in Telligent maintenance system and adjust the quality of the oil to be added, if required
 Danger !	Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.	Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
2	Start engine and run at 800...900 rpm with the highest gear engaged
3	Clean area around the check screw (1)
4	Unscrew check screw (1) on manual transmission
5	Check oil level	 Do not check the oil level immediately after driving the vehicle. Allow oil to cool down (approx. 30...40 °C oil temperature), to avoid any incorrect measurements.
		 The oil level must be level with the lower edge of the inspection hole, correct oil level, if necessary.
	Correct
6	Turn off engine
7	Clean area around the oil filler screw (2)
8	Remove oil filler screw (2) from torque converter clutch
9	Fill with oil slowly at the opening of the oil filler screw (2) until oil runs out at the opening of the check screw (1)
	Gear oils (Sheet 235.12)		BB00.40-P-0235-12A
		 The oil level must be at the bottom edge of the inspection opening. Collect transmission oil which flows out in a suitable vessel.
 Danger !	Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.	Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
10	Start engine and run at 800...900 rpm with the highest gear engaged
11	Check oil level	 The oil level must be at the bottom edge of the inspection opening. Drain off excess gear oil and collect in suitable container.
12	Screw in oil filler screw (2).	 Use new seal. Otherwise leaks will occur.
		 Screw plug to torque converter clutch	*BA25.40-N-1017-01C
13	Screw in check screw (1) with engine running	 Use new seal. Otherwise leaks will occur.
		 Close the inspection hole only when no more oil emerges.
		 Transmission 715.5Filling screw/inspection plug to transmission housing	*BA26.40-N-1011-01D
14	Turn off engine

 Torque converter clutch (WSK)

Number	Designation			ENGINE 541.9, 542.9 with CODE G02
BA25.40-N-1017-01C	Screw plug to torque converter clutch	M241.5	Nm	50
		M261.5	Nm	65

 Housing

Number	Designation		Transmission 715.500/507/510/513/517/520/527/540
BA26.40-N-1011-01D	Filling screw/inspection plug to transmission housing	Nm	60

เอกสารที่อ้างถึง