S25.20-4518-08
Shown on model 470 with engine 699 |
1 | Vent valve | 3 | Hose | |
2 | Clutch slave cylinder |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Topical note | Notes on working on clutch operating system | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
Topical note | Brake fluid notes | ||
Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | |||
Bleeding | |||
1 | Clean area surrounding brake fluid reservoir and remove cap from brake fluid reservoir | Assembly cleaner | |
2 | Attach filling unit with adapter at brake fluid reservoir and fill new brake fluid up to Max marking in brake fluid reservoir | ||
| 000 588 01 82 00 Filling unit | ||
Note operator's manual for filling unit. | |||
Brake fluid filling capacity | |||
Adapter | |||
3 | Raise vehicle | ||
4 | Remove rear center and middle lower engine compartment paneling | ||
5 | Remove dust cap from bleed valve(1) | ||
6 | Plug hose(3) of bleed bottle onto bleed valve(1) | Commercially available devices/tools | |
7 | Set pressure on filling unit to 2.0 bar and switch on filling unit | ||
8 | Open bleed valve(1) | Leave bleed valve(1) open until clean brake fluid flows out free of bubbles. | |
9 | Close the bleed valve(1) | Commercially available devices/tools | |
Vent valve at clutch slave cylinder | |||
10 | Detach hose(3) of bleed bottle from bleed valve(1) | Commercially available devices/tools | |
11 | Fit dust cap onto bleed valve(1) | ||
12 | Switch off filling unit | ||
13 | Install lower rear and center engine compartment paneling | ||
14 | Lower vehicle | ||
15 | Disconnect filling unit with adapter from brake fluid reservoir | ||
| 000 588 01 82 00 Filling unit | ||
Adapter | |||
16 | Check fill level in brake fluid reservoir, correct if necessary | ||
| |||
Commercially available devices/tools | |||
Brake fluid filling capacity | |||
17 | Fit cap onto brake fluid reservoir |
470 589 26 91 00
Adapter