1 | Clutch hydraulic line |
2 | Clamp |
3 | Bracket |
6 | Sealing rings |
D25.20-1113-06
1 | Clutch hydraulic line |
2 | Clamp |
D25.20-1121-11
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Topical note | Brake fluid notes | ||
Topical note | Notes on working on clutch operating system | ||
| Remove/install | ||
1 | Extract brake fluid from brake fluid reservoir. | To do so, open brake fluid reservoir. | |
Commercially available devices/tools | |||
| Clean | ||
2 | Clean clutch hydraulic line (1) in area of connecting point to clutch master cylinder. | Assembly cleaner | |
3 | Release clamp (2) from clutch master cylinder. | Release clamp (2) using suitable tool. | |
4 | Disconnect clutch hydraulic line (1) at connecting point to clutch master cylinder. | Collect escaping brake fluid and seal openings. | |
Record plug | |||
5 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
6 | Remove bottom engine compartment paneling. | If installed. | |
Only install lower engine compartment paneling after leak test. | |||
| Clean | ||
7 | Clean clutch hydraulic line (1) in area of connecting point to central clutch release bearing. | Assembly cleaner | |
8 | Release clamp (2) on central clutch release bearing. | Release clamp (2) using suitable tool. | |
9 | Disconnect clutch hydraulic line (1) at connecting point to central clutch release bearing. | Collect escaping brake fluid and seal openings. | |
Record plug | |||
10 | Remove clutch hydraulic line (1) downwards. | To do so, detach holder (3) from wheel well. | |
Installation: Check sealing rings (6) and holder (3) for damage. | |||
If corresponding findings exist, | |||
| |||
replace respective sealing ring (6) or holder (3). | |||
11 | Install in the reverse order | ||
12 | Bleed clutch actuation system. | ||
| Check | ||
13 | Check clutch operation system for leak tightness. | Visual inspection only. |
129 589 00 91 00
Record plug