S25.19-0001-08
1 | Switch for clutch pedal end position at front | 3 | Electrical connector | |
2 | Bracket | Y | Dimension |
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Remove driver kneebag | ||
2 | Turn switch for clutch pedal end position at front (1) 45° in clockwise direction and pull out of holder (2) | ||
3 | Release and disconnect electrical connector (3) and remove switch for clutch pedal end position at front (1) | ||
| Install | ||
4 | Plug electrical connector (3) into switch for clutch pedal end position at front (1) until it locks in to place | ||
5 | Push clutch pedal by hand into front end position | ||
6 | Insert switch for clutch pedal end position at front (1) into holder (2), adjust dimension (Y) and turn switch for clutch pedal end position at front (1) 45° in counterclockwise direction | Distance from housing of switch for clutch pedal front end position to contact surface on clutch pedal | |
7 | Release clutch pedal | ||
8 | Check if the bolt of the clutch master cylinder threaded rod can be easily moved by hand | ||
Bolt seated firmly in the clutch master cylinder threaded rod. | |||
| |||
Adjust switch for clutch pedal end position at rear. | |||
Bolt still firmly seated on clutch master cylinder threaded rod. | |||
| |||
Replace bolt of clutch master cylinder threaded rod. | |||
9 | Install driver kneebag |