S25.19-0002-08
Shown on model 470 with transmission 700.78 |
1 | Electrical connector | 4 | Pedal bracket | |
2 | Jam nut | 5 | Clutch pedal | |
3 | Switches | 6 | Pin |
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Remove driver kneebag. | ||
2 | Release electrical connector(1) and disconnect. | ||
3 | Loosen counternut (2). | ||
4 | Remove switch (3). | To do so, remove switch (3) from pedal bracket (4). | |
| Install | ||
5 | Install switch (3). | To do so, install switch (3) into pedal bracket (4). The threaded pin must make contact with the pedal stopper (arrow). Do not press the clutch pedal(5) out of the rear end position here. | |
6 | Tighten counternut (2). | ||
Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | |||
Commercially available devices/tools | |||
Jam nut, rear end position clutch pedal button to pedal bracket | |||
| Check | ||
7 | Check whether bolt (6) of threaded rod for clutch master cylinder can be moved to the side easily by hand. | If bolt (6) of threaded rod for clutch master cylinder is stuck: | |
| |||
Replace bolt (6) of threaded rod for clutch master cylinder. | |||
Assembly cleaner | |||
Molykote BR 2 plus grease | |||
8 | Connect electrical connector (1). | ||
9 | Install driver knee airbag. |