T20.40-0031-06
Shown on model 613.358 with rear axle 745.997
1 Water pipe
2 V-belt for fan drive
3 Fan bracket
4 Bearing
5 Fan wheel
6 Fan clutch
| Removing/installing | ||
Danger! | Lethal hazard of being drawn into rotating vehicle parts | Do not insert your hand into rotating parts. | |
1 | Open rear lid | See Operating Instructions | |
Danger! | Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles. Wear protective gloves, protective clothing and eye protection. | |
2 | Drain coolant | Close off shutoff valves for heating system. See owner's manual | |
| Notes on coolant | All engines | |
3 | Remove rear bumper | ||
4 | Remove water pipe (1) | The water pipe (1) is attached by a pipe clamp on the fan bracket (3). | |
5 | Remove V-belt on fan drive (2) | ||
6 | Disconnect electrical connector for fan clutch (6) | ||
7 | Remove fan bracket (3) from bearing (4) | Installation: Between the fan blade and radiator shroud there must be the same clearance over the whole circumference; align the fan wheel (5) with the fan bracket (3) if necessary. | |
8 | Remove fan bracket (3) with fan wheel (5) | First fold outwards at the top and lift out towards the rear. | |
9 | Detach fan wheel (5) from fan clutch (6) | ||
10 | Detach fan clutch (6) from fan bracket (3) | ||
11 | Install in reverse order | ||
| Checking | ||
12 | Check alignment of the belt pulley | Align the fan wheel (5) with the fan bracket (3) as necessary. |