P20.40-2029-09
1 Air intake pipes on left and right
2 Air filter
3 Bolts
4 Fan shroud
5 Electrical plug socket
11 Transmission oil/fluid line
12 Radiator
13 Retaining lug
6 Mounting clips
7 Coolant vent line
8 Securing clamps
9 Coolant line
10 Securing clamp
Modification notes
6.11.03 | Disconnect ground cable of battery, included for the first time | Step 1 | |
6.11.03 | Perform basic programming, newly recorded | Step 13 |
| Remove/install | ||
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
1 | Disconnect battery ground line | Do not connect quiescent current retention unit. | |
| Notes on battery | ||
2 | Remove coolant vent line (7) out of guide for fan shroud (4) and place to the side | ||
3 | Remove left and right air intake pipe (1) | ||
4 | Disconnect electrical plug socket (5) from fan shroud (4) | Cut through cable ties, replace. | |
5 | Remove bolts (3) at fan shroud (4) | ||
6 | Unclip clip retainers (6) | ||
7 | Detach transmission oil line (11) on radiator (12) | Seal the connections. | |
Installation: Check oil level, correct if required, see: | |||
Check oil level in automatic transmission, correct if necessary | |||
Union nut, transmission oil line to cooler | |||
Set of plugs. | |||
8 | Remove bottom section of soundproofing | ||
9 | Unscrew securing clamps (8) of coolant line (9) at fan shroud (4) | ||
10 | Unscrew securing clamps (10) of transmission oil line (11) at fan shroud (4) | ||
11 | Pull fan shroud (4) to the top and out of the guides of the radiator (12) | Installation: Ensure that the fan shroud (4) with the retaining lugs (13) is correctly seated in the guides of the radiator (12). | |
12 | Install in the reverse order | ||
13 | Perform basic programming |
Transmission oil cooling
Number | Designation | Trans-mission 722.6 in models 170, 171, 203, 209, 210, 215, 219, 220, 230, 240 | ||
BA27.55-P-1001-01B | Union nut connecting transmission oil line to cooler | Nm | 25 | |
Set of stop plugs
129 589 00 91 00