P20.20-0249-09
1 Radiator
2 Rubber grommet
3 Coolant hose, flow
4 Coolant hose, feed
9 Combination bolt
10 Cover
11 Condenser
12 Oil lines (automatic transmission)
5 Coolant hose, overflow
6 Retaining clamp
7 Rubber shim
8 Retaining clamp
| Remove/install | ||
Danger! | Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles. Wear protective gloves, protective clothing and eye protection. | |
1 | Drain coolant | For radiator only | |
2 | Remove front bumper | ||
3 | Remove fan shroud | ||
4 | Remove coolant hose (3, 4 and 5) from radiator (1) | Collect escaping coolant. Installation: replace clamps. Mount the coolant hose (3) clamp so that it is accessible through the opening in the bumper (tow eye). | |
5.1 | Remove oil lines (12) from radiator (1) | For vehicles with automatic transmission only | |
| |||
6 | Remove retaining clamp (6) with rubber shims (7) | ||
7 | Unscrew combination bolt (9) | ||
8 | Unclip retaining clamp (8) | To do this, press radiator (1) backwards | |
9.1 | Press radiator (1) with condenser backwards, and pull out of the grommet (2) on front-axle carrier | Condenser only on vehicles with air conditioning system (Code 580) | |
10.1 | Detach condenser (11) with cover (10) from guides on the radiator (1) | The condenser (11) and cover (10) remain on the vehicle. Condenser (11) only on vehicles with air conditioning system (Code 580) | |
11 | Remove radiator (1), pulling upwards | Be careful with the air conditioning lines | |
12 | Install in the reverse order | ||
| Inspecting | ||
13.1 | Check fluid level in automatic gearbox, correct if necessary | For vehicles with automatic transmission | |
14 | Check cooling system for leaks |
Radiator, coolant hoses