Shown on ENGINE 177 |
31 | Cover |
P09.40-2519-06
Shown on ENGINE 177 |
1 | Heat shield |
2 | Bolts |
P09.40-2516-06
Shown on ENGINE 177 |
14 | Electrical line |
16 | Ignition coil |
21 | Heat shield |
22 | Bolts |
P09.40-2515-06
Shown on ENGINE 177 |
3 | Vent line |
4 | Screw |
5 | Screw |
P20.20-2520-06
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
| Remove/install | ||
1 | Drain coolant from low-temperature circuit. |
| |
Engine 178 in model 190 | |||
Engine 177 in model 205 | |||
2 | Remove left and right air filter housing. | Engine 176 in model 463 | |
Engine 176 in model 463 | |||
3 | Remove cover (31). | Installation: Check for correct seating of the cover (31). | |
4 | Remove screws (2) and remove heat shield (1) upward. | Bolt, upper heat shield to bracket/side heat shield | |
5 | Unclip electric line (14) from heat shield (21). | Engine 176 in model 463 | |
6 | Remove ignition coil (16). |
| |
Engine 176 in model 463 | |||
7 | Remove screws/bolts (22). | Bolt, side heat shield to cylinder head cover | |
8 | Remove screws (4, 5). | Bolt, coolant line to turbocharger/cylinder head | |
9 | Lift heat shield (21) in the front area and remove bleed line (3). | Installation: Replace seals. | |
10 | Install in the reverse order. | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
11 | Perform engine test run and check engine for leak tightness. |