D20.10-1111-09
1 Coolant thermostat
2 Bolts
3 Charge air manifold
7 Coolant pipe
8 Screw
4 Cover
5 Coolant hose
6 Screw
| Remove/install | ||
1 | Drain coolant | ||
2 | Remove engine trim panel | ||
3 | Remove bolts (6, 8) and pull back coolant pipe (7) | ||
4 | Detach coolant hose (5) at charge air manifold (3) | Installation: Check clamp, replace if necessary. | |
5 | Lift cover (4) and unscrew bolts (2) | Installation: Cover (4) must engage correctly in cylinder head cover. | |
| |||
6 | Remove coolant thermostat (1) on charge air manifold (3) | Installation: Clean seal on coolant temperature sensor (1), if applicable, replace coolant temperature sensor (1) and clean sealing surface on charge air manifold (3). | |
7 | Install in the reverse order | ||
| Checking | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
8 | Test run engine and check function of coolant thermostat (1) |
Coolant pump, coolant thermostat