1 | Flywheel / drive plate |
2 | Pulse ring |
3 | Crankcase |
4 | Oil pan |
5 | End cover |
6 | Radial shaft sealing ring |
P03.20-2342-06
| Remove/install | ||
1 | Remove flywheel/driven plate (1) | ||
2 | Remove crankshaft Hall sensor | ||
3 | Remove pulse ring (2) | | |
| |||
Installation: The cylinder pin for the crankshaft determines the installation position of the pulse ring (2). | |||
| Check | ||
4 | Check rubber lining of pulse ring (2) for damage | If damage occurs to the rubber lining | |
| |||
Replace pulse ring (2). | |||
5 | Check end cover (5) and radial shaft sealing ring (6) for leaktightness | In the case of leaks on the end cover (5) or the radial shaft sealing ring (6) | |
| |||
Replace end cover (5) with radial shaft sealing ring (6). | |||
| Clean | ||
6 | Clean the contact surfaces of the pulse ring (2) and the crankshaft flange | Installation: | |
Assembly cleaner | |||
7 | Clean crankcase (3) and oil pan (4) in area of end cover (5) | Assembly cleaner | |
8 | Install in the reverse order | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
9 | Perform an engine test run and check engine for proper function |