1 | Flywheel / drive plate |
2 | Pulse ring |
3 | Crankcase |
4 | Oil pan |
5 | End cover |
5a | Bolts |
6 | Radial shaft sealing ring |
P03.20-2342-06
Caution | Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove | ||
1 | Remove flywheel/driven plate (1) | ||
2 | Remove crankshaft Hall sensor | ||
3 | Remove pulse ring (2) | ||
4 | Clean crankcase (3) and oil pan (4) in area of end cover (5) | Assembly cleaner | |
5 | Remove screw/bolts (5a) | ||
6 | Place tool on the side cutouts of the end cover (5) and unfasten the end cover (5) from crankcase (3) | | |
Heat end cover (5) in area of the sealing surfaces if necessary using a heat gun. | |||
7 | Replace end cover (5) with radial shaft sealing ring (6) | The end cover (5) and radial shaft sealing ring (6) form a unit and can only be replaced together. | |
| Install | ||
8 | Install new end cover (5) with a new radial shaft sealing ring (6) | ||
Loctite 7200 | |||
Assembly cleaner | |||
Sealant, Loctite 5970, 50 ml | |||
Screw, rear end cover to crankcase/oil pan (belt side) | |||
Installation tool | |||
9 | Install pulse ring (2) | ||
10 | Install crankshaft Hall sensor | ||
11 | Install flywheel/drive plate (1) | ||
12 | Check engine oil level and correct | ||
| |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
13 | Carry out an engine test run; in doing check engine for leaktightness |
271 589 00 43 00
Installation tool