P15.10-2412-09
Shown on model 204.057 |
1 | Resonance intake manifold | B6/4 | Left intake camshaft Hall sensor | B6/7 | Right exhaust camshaft Hall sensor | ||
2 | Air filter housing | B6/5 | Right intake camshaft Hall sensor | ||||
3 | Screw/bolt | B6/6 | Left exhaust camshaft Hall sensor |
| Remove/install | ||
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
1 | Remove engine cover | Installation: Ensure correct seating of the engine cover. | |
2 | Remove resonance intake manifold (1) | ENGINE 276.9 | |
3.1 | Detach air filter housing (2) from cylinder head cover | ENGINE 276.9 | |
ENGINE 276 (except 276.8) in MODEL 204, 207 | |||
ENGINE 276 (except 276.8) in MODEL 204, 207 | |||
3.2 | Remove left engine air intake duct with raw air line upstream of air filter housing | ENGINE 276.8 | |
3.3 | Remove right air filter housing | ENGINE 276.8 | |
4 | Detach connector from the respective camshaft Hall sensor (B6/4, B6/5, B6/6, B6/7) | ||
5 | Remove screw/bolt (3) and pull respective camshaft Hall sensor (B6/4, B6/5, B6/6, B6/7) out of the cylinder head cover | Installation: Replace sealing ring. | |
Bolt, camshaft Hall sensor to cylinder head cover | |||
6 | Install in the reverse order | ||
7 | Read out fault memory with STAR DIAGNOSIS and clear if necessary | ||
| |||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
8 | Carry out an engine test run, checking the engine for proper operation and leaktightness |