AR14.40-W-2014R | Remove/install AdBlue container | 28.1.09 |
ENGINES 926.9 in MODEL 949
with CODE (MS5) BlueTec 5
with CODE (KP2) AdBlue tank, 35 liters
W14.40-1475-06
1 AdBlue tank
2 Cover
3 Insulating hose
4 Insulating hose
5 Coolant line
6 AdBlue line
7 AdBlue line
8 Coolant line
9 Retaining rail
10 Electrical connector
11 Vent line
B117 Fill level and SCR AdBlue temperature combination sensor
| Remove/install | ||
Danger! | Risk of burn injuries and scalding when working at AdBlue lines and the components attached to them. Risk of injury to skin and eyes when handling AdBlue. Risk of poisoning from swallowing AdBlue | Only pour AdBlue into suitable containers. Only begin work on the exhaust aftertreatment system after releasing the pressure. | |
| Notes on use, material properties and handling AdBlue | ||
| Notes on self-locking nuts and bolts | ||
1 | Switch off ignition | ||
2 | Open engine hood and move to vertical position | ||
Danger! | Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | |
3 | Release pressure in coolant circuit | ||
| Notes on coolant | ||
4 | Take off cover (2) | Installation: Replace removed cable tie. | |
5 | Detach electrical connector (10) and remove electrical line from set of hoses. | Installation: Replace removed cable tie. | |
6 | Disconnect vent line (11) for AdBlue tank at separation point. | Vehicles with code (Z69) Vehicles capable of fording up to 1500 mm or with code (Z90) Vehicles capable of fording up to 1195 mm. | |
7 | Open insulating tubing (3, 4) to a length of approx. 10 cm and push back | | |
8 | Clamp off coolant lines (5, 8) | | |
9 | Clamp off AdBlue lines (6, 7) | | |
10 | Remove coolant lines (5, 8) from line connections | Installation: Collect coolant in clean container. Pour coolant caught previously back into coolant circuit after installing AdBlue tank (1). | |
11 | Remove AdBlue lines (6, 7) from line connections | ||
12 | Remove fill level and SCR AdBlue temperature combination sensor (B117) | Only if the AdBlue container (1) is replaced. | |
13 | Empty AdBlue tank (1) | Do not reuse used AdBlue since contaminated AdBlue can lead to damage in exhaust aftertreatment system. | |
14 | Remove AdBlue tank (1) | ||
15 | Install in the reverse order | ||
16 | Check line separation points for leakage. | Visual inspection. | |
17 | Close engine hood |
950 589 01 37 00
Roller tongs
Clamping device
000 589 54 37 00