N13.30-2018-01
N13.30-2019-01
N13.30-2008-01
N13.30-2015-01
N13.30-2016-01
N13.30-2017-01
| Removing | ||
| The piston and cylinder liners must always be installed with the same dimensions | ||
1 | Remove compressor cylinder head | ||
2 | Pull down cylinder liner (1) over the piston | Position cylinder liner (1) relative to the cylinder crankcase and mark relative to the piston. | |
3 | Remove securing clamp (2) for the piston pin | ||
4 | Press down piston pin (3), remove piston (4) and clean | ||
| Install | ||
5 | Place piston (4) on the connecting rod and insert piston pin (3) | Observe marking. Lubricate piston pin (3) using engine oil. | |
6 | Secure piston pin using a securing clamp (2) | ||
7 | Lubricate piston with engine oil | Place piston ring slit offset by 120°. | |
8 | Clean sealing surface between the cylinder liner (1) and cylinder crankcase | ||
9 | Coat sealing surface between the cylinder liner (1) and the cylinder crankcase with sealant | ||
10 | Press piston rings together | | |
11 | Press cylinder liner over the piston | Observe marking. | |
12 | Pre-tension cylinder liner in a crosswise pattern using two hexagon head bolts | ||
13 | Measure piston projection without the seal in place | ||
| |||
| |||
14 | Install compressor cylinder head |
Test and adjustment values for pistons
Number | Designation | Engine 384.906/ | |
BE03.10-N-1002-02H | Piston projection in top dead center without cylinder head gasket | mm | 0.04 to 0.40 |
001 589 53 21 00
Chuck
Dial indicator
Dial indicator holder
343 589 00 40 00
000 589 20 61 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1029-01A | Curil T sealant | - |