Remove/install poly-V belt

AR13.22-P-1202EH

15.11.2019

Engine

651.9 in model 212.098/298

P13.22-2189-09

1	Poly-V-belt	4	Bolts	6	Poly-V belt tensioning device
2	Bolts	5	Electrical connector	M56	Vacuum pump
3	Circulation pump holder

 	Remove/install
 Warning	Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
 Danger	Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)	Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.	AS00.00-Z-0035-01A
1	Remove cylinder head cover trim
2	Remove fan unit		AR20.40-P-5050EW
3	Remove screws (2)
4	Unhook bracket for the circulation pumps (3) in the upper area and lay outside the working area to the front
5	Remove screw/bolts (4)
6	Disconnect electrical connection (5) and lay vacuum pump (M56) to the side until the poly-V belt tensioning device (6) is accessible
7	Loosen poly-V-belt (1) and remove		AR13.22-P-3902-01T
	Pin for locking poly-V belt tensioning device		WF58.50-P-1325-02A
		 Installation: Do not use belt wax or similar products. Slipping of the poly-V belt (1) can occur otherwise.
		 Installation: Fit on poly-V belt (1) as per routing diagram and tension.

		

		Routing diagram for poly-V belt	AR13.22-P-3902-02CD
		Tension poly-V-belt	AR13.22-P-3902-04T
8	Check poly-V belt (1) for damage and wear; replace if necessary
			AP13.22-P-1352CW
9	Install in the reverse order