P13.22-2113-11
1 Poly-V belt
2 Tensioning device
| Removing | ||
1 | Remove engine trim panel | ||
2 | Remove engine charge air channel upstream of charge air cooler | ||
3 | Loosen poly-V belt (1) | In order to slacken the poly-V belt (1), turn tensioning device (2) in the direction of the arrow and use a 4-mm drill bit for locking. | |
4 | Remove poly-V belt (1) | ||
| Checking | ||
5 | Inspect belt pulley sections and tensioning device (2) for damage and dirt | Installation: In the event of damage to belt pulley or tensioning device (2), these must be replaced. | |
6 | Check poly-V belt (1) | Installation: In the event of wear and tear or damage, poly-V belt (1) must be replaced. | |
| Check visible area of poly-V belt for wear | ||
| Install | ||
7 | Fit on poly-V belt (1) | Do not use belt wax or any similar products. | |
When fitting the poly-V belt (1), the routing diagram must be observed, see: | |||
Routing diagram of poly-V belt | |||
8 | Install engine charge air channel upstream of charge air cooler | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
9 | Carry out engine test run | ||
10 | Reinstall engine cover |