P13.20-2067-06
1 Poly-V-belt
2 Poly-V belt tensioning device
3 Serration
4 Bolts
5 Pulley
6 Bolt
7 Pulley
8 Bolt
12 Pulley
13 Bolts
P13.20-2064-04
9 Cover
10 Carrier
11 Bolts
| Removing | ||
Danger! | Risk of injury caused by moving parts that can pinch, crush or, in extreme cases, even sever extremities | No parts of the body or limbs should be within the operating range of the mechanism when moving components. | |
1 | Remove cylinder head cover trim | ||
2 | Remove engine intake air duct upstream of air filter housing | ||
3 | Remove cover (9) for belt drive | To do this detach cover (9) for upper belt drive to the front and upwards. | |
4 | Remove carrier (10) for cover (9) | To do this remove bolts (11) and carrier (10). | |
| Remove/install poly-V belt | ||
5 | Loosen poly-V belt (1) and remove | Do not use wax or similar products, as this may cause poly-V belt (1) to slip. | |
| Pin for locking poly-V belt tensioning device | ||
Installation: Put poly-V belt (1) in place according to the routing diagram. | |||
| Checking | ||
6 | Check profile of belt pulley and poly-V belt tensioning device (2) for damage and soiling | ||
7 | Check poly-V belt (1) for damage and wear; replace if necessary | ||
| Check visible area of poly-V belt for wear | ||
8 | Install in the reverse order | ||
| Remove/install poly-V belt tensioning device | ||
9 | Tighten poly-V belt tensioning device (2) and lock in place with a pin | ||
| Pin for locking poly-V belt tensioning device | ||
10 | Remove bolts (4) and poly-V belt tensioning device (2) | Bolt, poly-V belt tensioning device to major assembly carrier | |
| Checking | ||
11 | Check poly-V belt tensioning device (2) for damage and soiling; replace if necessary | ||
12 | Remove drift and detension poly-V belt tensioning device (2) | Only when replacing the poly-V belt tensioning device (2). | |
13 | Install in the reverse order | ||
| Remove/install guide pulleys | ||
14 | Remove bolt (6, 8, 13) and guide pulleys (5, 7, 12) | Bolt, guide pulley to major assembly carrier | |
15 | Install in the reverse order | ||
| Install | ||
16 | Install carrier (10) for cover (9) | ||
17 | Install cover (9) for belt drive | ||
18 | Install engine intake air duct upstream of air filter housing | ||
19 | Install trim panels of cylinder head cover | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
20 | Carry out engine test run |
Belt tensioning device