S09.41-A008-79
1 | Boost pressure sensor | 3 | Screw | 4 | Mixing chamber | ||
2 | Electrical connector |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Remove air intake pipe. | ||
Installation: Only install air intake pipe after leak test. | |||
2 | Clean area around boost pressure sensor (1). | Assembly cleaner | |
3 | Disconnect electrical connection (2). | ||
4 | Remove screw (3). | Bolt, boost pressure sensor to mixer housing | |
5 | Remove boost pressure sensor (1) from mixer housing (4) and remove in upward direction. | ||
6 | Seal opening in mixer housing (4) with a stop plug. | Record plug | |
7 | Check sealing ring for damage. | If boost pressure sensor (1) is not replaced. | |
If damage is identified, | |||
| |||
replace boost pressure sensor (1). | |||
8 | Install in the reverse order | ||
| Check | ||
9 | Read out and delete fault memory. | ||
| |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
10 | Perform engine test run and check mixer housing (4) in the area of boost pressure sensor (1) for leaks. |
129 589 00 91 00
Record plug