1 | Intake manifold |
2 | Hose |
3 | Air intake hose |
4 | Clamp |
5 | Bracket |
6 | Hose |
7 | Clip |
8 | Hose |
9 | Clip |
10 | Hose |
11 | Clip |
12 | Fuel line |
13 | Bracket |
S09.20-4533-06
14 | Hose |
15 | Bracket |
16 | Hose |
17 | Bracket |
S09.20-4534-03
1 | Intake manifold |
18 | Screw |
19 | Screw |
20 | Screw |
21 | Nut |
22 | Nut |
23 | Stud bolts |
24 | Seal |
S09.20-4535-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | Notes on using electrical or pneumatic screwdrivers/impact wrenches | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
| Remove/install | ||
1 | Remove throttle valve actuator | ||
2 | Remove hose (2) from intake manifold (1), and place out of working area together with air intake hose (3) | To do this, open clip (4), and unclip hose (2) from bracket (5). | |
3 | Remove hose (6) from intake manifold (1) | To do this, release clamp (7). | |
Hose clamp pliers | |||
4 | Remove hose (8) from intake manifold (1) | To do this, release clamp (9). | |
Hose clamp pliers | |||
5 | Remove hose (10) from intake manifold (1) | To do this, release clamp (11). | |
Hose clamp pliers | |||
6 | Remove fuel line (12) from intake manifold (1) | To do this, unclip fuel line (12) from bracket (13). | |
7 | Remove front right wheel | ||
8 | Remove right fender liner | ||
9 | Remove hose (14) from intake manifold (1) | To do this, unclip hose (14) from brackets (15). | |
10 | Remove hose (16) from intake manifold (1) | To do this, unclip hose (16) from brackets (17). | |
11 | Remove intake manifold (1) | To do this, unscrew nuts (21, 22), and remove screws/bolts (18, 19, 20). | |
Installation: Replace seal (24). | |||
Nut/bolt, intake manifold to cylinder head | |||
| Check | ||
12 | Check stud bolts (23) | Stud bolt to cylinder head | |
Depending on findings | |||
| |||
Replace stud bolts (23). | |||
13 | Install in the reverse order | ||
| Check | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
14 | Check for leaktightness with engine running | Visual inspection only. |
454 589 00 37 00
Hose clamp pliers