ar0708s7009ps

Remove/install diesel fuel injection system control unit

ประเภท ar · หัวข้อ 07.08 · เวอร์ชัน 0100 · 2018-06-06

ใช้กับ: Engine 642 in model 470, 471

ไม่มีใน “th” แสดงเป็น อังกฤษ

ตำแหน่ง

กลุ่มฟังก์ชัน 1 Engine › 07 Mixture formation › 07.08 Governor — ซีรีส์ 470 · ซีรีส์ 471

EinPAS 15 Engine › 15.45 Engine management › 15.45.11 Control unit/relay — ซีรีส์ 470 · ซีรีส์ 471

ใช้กับเครื่องยนต์/เกียร์ด้วย: 642 ***

AR07.08-S-7009PS

Remove/install diesel fuel injection system control unit

22.05.2018

Engine

642 in model 470, 471

Remove/install diesel fuel injection system control unit

S07.08-4537-78

1

Diesel injection system control unit

5

Bracket

2

Electrical connector

6

Air duct segment

3

Electrical connector

7

Nuts

4

Retaining clips

Remove/install diesel fuel injection system control unit

1

Diesel injection system control unit

6

Air duct segment

8

Bolts

S07.08-4538-75

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Connect vehicle diagnosis system and carry out initial startup of the diesel injection system control unit (1).

If the diesel injection system control unit (1) is replaced.

Notes on programming control units

AH54.21-P-0001-03Z

AD00.00-S-2000-06P

2

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

3

Remove upper engine cover.

4

Remove retaining clamps (4) with attached engine wiring harness and vehicle wiring harness from bracket (5).

5

Release and disconnect electrical connector (2).

6

Release and disconnect electrical connection (3).

7

Pull air duct segment (6) with attached diesel injection system control unit (1) out of the elastomer bearing and remove.

Installation: Pay attention to the correct seating of the air duct segment (6) in the elastomer bearing.

8

Unscrew nuts (7) and remove bracket (5).

If the diesel injection system control unit (1) is replaced.

9

Remove bolts (8).

If the diesel injection system control unit (1) is replaced.

10

Remove diesel injection system control unit (1) from air duct segment (6).

If the diesel injection system control unit (1) is replaced.

11

Install in the reverse order.

Check

Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

12

Perform an engine test run and check the engine for proper function.

เอกสารที่อ้างถึง