Shown on model 177 |
1 | Bolts |
2 | Electrical connectors |
N3/9 | CDI control unit |
P07.08-2362-06
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Notes on safety-relevant components | |||
| Remove/install | ||
1 | Perform commissioning of CDI control unit (N3/9). | When replacing the CDI control unit (N3/9). | |
| |||
2 | Clamp off ground line of on-board electrical system battery (G1). | ||
3 | Remove screws (1) at CDI control unit (N3/9). | Bolt, control unit to air filter housing upper part | |
4 | Release and disconnect electrical connectors (2) at CDI control unit (N3/9). | The electrical connectors (2) are coded and cannot be interchanged. | |
5 | Install in the reverse order. | ||
| Check | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Warning | Risk of burn injuries, suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust. | Wear protective clothing and safety glasses. Use the extraction system. Move people out of the hazard area. | |
6 | Perform engine test run; in this connection, check engine for proper operation. |