D07.04-A017-79
1 | Crankshaft position sensor | 2 | Electrical connector | 3 | Screw |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
2 | Remove lower engine compartment lining | Model 907.1/2/6 with code XM1 (Noise abatement measures) | |
3 | Remove underfloor paneling at left. | Model 907.1/2/6 with code XM1 (Noise abatement measures) | |
4 | Thoroughly clean area around crankshaft position sensor (1). | Assembly cleaner | |
5 | Release and disconnect the electrical connector (2). | ||
6 | Remove screw (3). | Screw, position sensor of crankshaft to timing case | |
7 | Remove crankshaft position sensor (1). | ||
8 | Install in the reverse order. | ||
| Check | ||
9 | Read out and delete fault memory. | ||
| |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
10 | Perform engine test run. |