Remove/install race on flywheel

AR03.30-W-8350CA

23.9.10

ENGINES 457.9 in MODEL 374, 375, 940, 942, 943, 944, 958 with CODE (N52) Rear engine power take-off, output torque 600 Nm

ENGINES 457.9 in MODEL 374, 375, 940, 942, 943, 944, 958 with CODE (N53) Rear engine output for hydraulic pump

W03.30-1071-09

1 Flywheel

2 Race

5  Drift

6  Adapter

3  Thrust piece

4  Puller

	Removing
1	Remove flywheel (1)		AR03.30-W-8002C
2	Use puller (4) to pull race (2) off flywheel (1)	 Insert to detach thrust piece (3) in flywheel (1).
		 Puller	*000589453300
		 Thrust piece	*312589001500
3	Remove radial shaft sealing ring on timing case		AR03.20-W-3063C
	Install
4	Lay adapter (6) in the drift (5)	 Drift	*403589031500
		 Adapter	*403589031503
 Danger!	Risk of injury to skin and eyes caused by handling hot or glowing objects.	Wear safety gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
5	Heat up new race (2)	 Heat race (2) to a temperature of a maximum of 60°C. The race (2) must not have any temper color; replace race (2) if required.
	Race for the radial shaft sealing ring on flywheel altered		BT03.30-W-0006-01A
6	Place race (2) on flywheel (1)	 The rounded edge of the race (2) must point towards the drift (5).
7	Reset race (2) on flywheel (1) with drift (5) and engaged adapter (6)	 The  drift (5) and the  adapter (6) determine the installation depth of the race (2) on the flywheel (1).
8	Install new radial shaft sealing ring in the timing case	 Install radial shaft sealing ring with a large inside diameter.	AR03.20-W-3063C
9	Install flywheel (1)	 The race (2) on flywheel (1) must be cooled off.	AR03.30-W-8002C

312 589 00 15 00

Drift

Thrust piece

Puller

Adapter

000 589 45 33 00

403 589 03 15 00

403 589 03 15 03