Check basic position of balancing shaft

AR03.20-P-3637OLD

3.8.15

Engine

651 in model 205, 253

P03.20-2292-08

1	Balance shafts		B	Marking on the balance shaft
A	Marking on balance shaft housing

	Remove
1	Secure vehicle on vehicle lift		AR00.60-P-0100CW
2	Remove lower engine compartment paneling		AR61.20-P-1105LW
3	Remove oil pan		AR01.45-P-7500OLD
4	Remove oil suction pipe		AR18.10-P-4020OLD
5	Remove oil deflector
	Check
6	Set piston on cylinder 1 with the counterholder to TDC (ignition TDC)	 Rotate engine at crankshaft in direction of engine rotation until the 0° marking on the belt pulley/vibration damper coincides with the marking on the major assembly carrier.
		 Counterholder	*651589074000
7	Check basic position of the balance shafts (1)	 The marking on the balance shaft housing (A) and marking on the balance shaft (B) must be aligned with each other.
		If this is not the case.
		
		Bring balance shaft (1) into the basic position
			AR03.20-P-3638OLD
	Install
8	Install oil deflector	 Bolt, oil deflector to bearing housing	*BA18.10-P-1003-01O
9	Install oil suction pipe		AR18.10-P-4020OLD
10	Install oil pan		AR01.45-P-7500OLD
11	Install lower engine compartment paneling		AR61.20-P-1105LW
12	Unfasten vehicle from vehicle lift		AR00.60-P-0100CW
 Danger !	Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.	Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
13	Check leaktightness of engine for a running engine

 Oil pump

Number	Designation			Engine 651
BA18.10-P-1003-01O	Bolt, oil deflector to bearing housing	Stage 1	Nm	6
		Stage 2	°	90

651 589 07 40 00

Counterholder