AR01.20-W-5014A | Remove, install cylinder head cover | 19.9.06 |
ENGINE 904.9 in MODEL 668, 670
ENGINE 904.9 in MODEL 374, 375, 673, 674, 676, 958, 970, 972, 975, 976
ENGINE 906.9 in MODEL 374, 958, 970, 972, 974, 975, 976
ENGINE 906.9 in MODEL 374, 375, 950, 952, 953, 954, 958
ENGINE 906.9 in MODEL 957 except CODE (MS8) Natural gas engine
W01.20-1017-06
Shown on engine 904.9
1 Bolt
2 Sealing washer
3 Crankcase ventilation hose
4 Cylinder head cover
5 Seal
6 Engine trim panel
W26.60-1011-11
Shown on engine 906.9 with code (GS3) "Hydraulic" gearshift
30 Hydraulic lines
31 Clamps
32 Bracket
33 Bolt
| Remove/install | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within tilting range of cab as it is being tilted. Always tilt cab all way to end position and secure with safety strut. | |
1.1 | Tilt cab | Model 374, 375, 673, 674, 676, 950, 952, 953, 954, 957, 958, 970, 972, 974, 975, 976 | |
| Notes on tilting the cab | ||
1.2 | Remove service cover | Model 668, 670 | |
2 | Remove engine panel (6) | ||
3 | Remove hydraulic lines (30) with bracket (32) and clamp (31) on engine and place aside | Only if code (GS3) "hydraulic" gearshift fitted. Do not disconnect hydraulic lines (30). | |
4 | Detach crankcase ventilation hose (3) at cylinder head cover (4) | ||
5 | Remove bolts (1) and cylinder head cover (4) | Installation: Replace sealing washers (2) and gasket (5) on cylinder head cover (4). | |
| |||
6 | Install in the reverse order |
Crankcase ventilation, cylinder head cover