000 589 30 37 00
Wire stripper
1 | Expose damaged line or plug/coupling in an easily accessible position and cut off. |
Separate strands in wiring harness offset by approximately 45 mm (a) as shown. |
P54.18-5290-01
P54.18-5287-09
2 | Cut new section of cable to match old cable. |
3 | Strip 15 mm of insulation from ends of the line as shown with wire stripper. |
Lines may only be stripped with the wire stripper. |
4 | Select axial solder connector by means of cable cross-section. |
5 | Push the axial solder connector on line beyond the solder point. |
Push on the thinner side of the axial solder connector first. |
P54.18-3999-01
6 | Twist the line ends together. |
7 | Push back the axial solder connector on the transposition while turning. |
P54.18-4000-01
8 | Heat up axial solder connector with a preheated hot air blower (with electronic temperature control) to 400 °C. |
Use welding pearl catcher in vehicle interior. |
P54.18-4001-01
9 | Check soldered point. |
It must not be possible to see the soldering ring of the axial soldered connector any more. The covering must be flush with the lines. |
A | Correct |
B | Incorrect |
P54.18-4002-01
10 | Apply axial solder connector to the lines and wrap repaired area with duct tape. |
The axial solder connectors must not lie directly above one another. |
P54.18-5291-10