Engine | 457.9 in model 695.0 |
Engine | 460.984 in model 934.241/251, 938.14 |
Engine | 612.9 in model 979.01 |
Engine | 904.9, 906.9, 924.9, 926.9 in model 693, 694, 695 |
Engine | 904.9, 906.9, 924.9, 926.9 in model 958.0/1 |
except code K81 (Fuel prefilter with heated water separator) | |
Engine | 904.9, 924.9 in model 979 |
B47.00-0012-01
B47.00-0003-01
1 | Cylinder head |
2 | Seal ring |
3 | Filter element |
4 | Seal ring |
5 | Transparent bowl |
6 | Drain plug |
B07.00-0005-01
| Remove | ||
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
Notes on tilting the cab | |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
1 | Tilt the cabin | In some models, the access to the fuel pre-filter is made easier by tilting the cabin. | |
2 | Drain the fuel through the drain plug (6) | Utilize an adequate recipient for the drained fuel. | |
3 | Remove the filtering element (3) together with the transparent cup (5) and the sealing ring (2) | ||
4 | Remove the transparent cup (5) from the filtering element (3) and the sealing ring (4) | Eliminate the filtering element (3) in an correct ecological manner. | |
| |||
If the filtering element (3) presents excessive dirt: | |||
| |||
Clean fine-mesh suction filter of fuel tank | |||
| Clean | ||
5 | Clean the transparent bowl (5) | Pay attention to clean also the sealing ring groove (4). | |
| Install | ||
6 | Tighten the drain plug (6) | ||
7 | Assemble the transparent cup (5) in the new filtering element (3) | Apply thin layer of engine oil to the sealing ring (4). | |
8 | Install the set (filter and cup) in the crankcase (1) and tighten firmly manually | Supply with clean diesel oil before installing it in the crankcase. | |
Apply a thin layer of engine oil on the seal ring (2). | |||
9 | Carry out the fuel system's bleeding |
| |
10 | Run the motor and check the fuel system tightness |