AP42.10-T-4291B | Automatic brake adjusters - Checking wheel cylinder release travel | 10.1.08 |
MODEL 613.364 /365
with HOSE rear axle for O560,
with VOSE front axle for O560
T42.10-0004-01
Shown on VOSE front axle
(example)
a Release travel of wheel brake cylinder
Shown on HOSE rear axle
(example)
a Release travel of wheel brake cylinder
T42.10-0003-01
Modification notes
8.8.00 | Figure revised from 44 to 60 mm to 34.4 to 57.0 mm | Value changed to BE42.10-N-1001-10F on model 613.365 with HOSE rear axle |
| Check | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
1 | Start engine | ||
2 | Increase pressure of compressed-air system to operating pressure | Keep the compressed air system at operating pressure while testing the individual linkage adjusters. | |
3 | Secure vehicle against rolling | ||
4 | Release parking brake | ||
5 | Measure release travel (a) of wheel brake cylinder between full-load position (7 bar) and released service brake | Actuate and release service brake. The measured value must not exceed the test value. |
Test and adjustment values for service brake