P42.00-2198-07
01 | Filling and bleeding device | 1 | Cap | |
02 | Vent hose | 2 | Expansion reservoir |
1 | Cap |
2 | Expansion reservoir |
P42.00-2200-05
Danger ! | Risk of accident when commissioning the vehicle due to a lack of braking effect when the service brake is operated for the first time after repair work. | Before starting the engine, actuate brake pedal several times until pressure is built up and maintained in the brake system. | |
Danger ! | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Danger ! | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
| Notes on handling, transport and storage of ceramic brake disks | ||
| Brake fluid notes | ||
| Notes on repairs to brake system | ||
Preparatory activity | |||
1 | Open engine hood | ||
| |||
| Clean | ||
2 | Clean area surrounding cap (1) and expansion reservoir (2) | ||
| Remove | ||
3 | Unscrew cap (1) | ||
4 | Suction off brake fluid from the expansion reservoir (2) | ||
5 | Add new brake fluid up to the Max. marking in the expansion reservoir (2) | ||
6 | Connect filling and bleeding unit (01) to expansion reservoir (2) and switch on | Observe the operator's manual for the filling and bleeding unit (01). | |
Change fluid | |||
7 | Lift vehicle on vehicle lift | ||
| |||
8 | Replace brake fluid | ||
| General brake fluid | ||
| Brake fluids (DOT 4 plus) | ||
Bleed screw on front axle brake caliper | |||
Bleed screw on rear axle brake caliper | |||
New brake fluid must escape without any bubbles via the bleed hose: | |||
| |||
Bleed the system. | |||
| |||
| Check | ||
9 | Check brake system for leaks | If there are problems: | |
| |||
Rectify problem subject to separate repair order. | |||
| Install | ||
10 | Lower vehicle with lifting platform | ||
11 | Disconnect filling and bleeding unit (01) | ||
12 | Screw on cap (1) | ||
| Check | ||
13 | Check fluid level in expansion reservoir (2) |