Remove/install wheels, rotate if necessary

AP40.10-P-4050SX

14.11.2018

Model	216
Model	221

Remove/install wheels, rotate if necessary

P40.10-4105-01

Left illustration
1 bis 5	Tightening sequence

	Right figure
	Pfeile	Interchange wheel-and-tire assemblies (vehicles without mixed tires)

P40.10-4106-01

 Danger	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Topical note	Information on tires / rims		AH40.10-P-9411-01A
	Remove
1	Raise vehicle with vehicle lift
			AR00.60-P-1000SX
2	Unfasten wheel bolts and wheels using wheel lift	 Note modified wheel bolts for "17 inch" forged wheel (long wheel bolt).
	Check
3	Check tires for signs of damage and make sure that they are in good condition		AP40.10-P-4051Z
4	Clean and check wheel bolt connection components, then protect against corrosion		AP40.10-P-4050-01A
		 Before mounting a wheel-and-tire assembly all the operation steps listed in the linked description must be conducted carefully. The complete wheel can otherwise work its way loose from the vehicle.
		Paste, hot lubrication 1 kg, DBL 6879.20	*BR00.45-Z-1005-06A
	Install
5	Change round wheel-and-tire assemblies on front and rear axles	If necessary, subject to separate repair order and only for vehicles without mixed tires.
		 Maintain running direction of wheel-and-tire assemblies. Otherwise handling characteristics and handling comfort may be impaired and tire wear increased.
6	Mount wheels using wheel lift and tighten wheel bolts	 Observe the tightening sequence (1 to 5) and tightening torque.
		 Note modified wheel bolts for "17 inch" forged wheel (long wheel bolt).
		 Bolt, disk wheel to wheel hub or flange	*BA40.10-P-1001-01L
7	Lower vehicle
8	Correct tire pressure of front and rear axle tires		AP40.15-P-4061A
		In the event of unusual tire pressure loss:
		
		Determine and rectify cause, subject to separate repair order.
9.1	Activate tire pressure loss warning	Model 216 Model 221 except code 475 (Tyre pressure monitoring system)
			AR54.30-P-1000-02RAW
		 Only for wheel-and-tire assembly change, tire replacement or a change in tire pressure.
9.2	Activate the tire pressure monitoring system	Model 216 Model 221 with code 475 (Tyre pressure monitoring system)
			AR54.30-P-1000-02RAS
		 Only for wheel-and-tire assembly change, tire replacement or a change in tire pressure.

 Wheels

Number	Designation		Model 216	Model 221
BA40.10-P-1001-01L	Bolt, disk wheel to wheel hub or flange	Nm	150	150

Repair materials

Number	Designation	Order number
BR00.45-Z-1005-06A	Paste, hot lubrication 1 kg, DBL 6879.20	A 000 989 76 51

เอกสารที่อ้างถึง