AP40.10-D-4040A | Remove/fit rear wheels | 23.8.11 |
MODEL 903.6, 904.6, 905.6
as of model year 2003
MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7
N40.10-2177-01
1 Attaching lug nut
2 Spherical spring washer
3 Disk wheels
| Remove/install | ||
| Notes on lug bolts | ||
1 | Secure vehicle against rolling | ||
2 | Raise vehicle and support using jack stand | The vehicle frame may be damaged if the jack stands are not attached correctly. | |
Position jack stands on longitudinal frame member upstream of the rear axle. | |||
3 | Remove wheels | Installation: Tighten attaching lug nut (1) diagonally. | |
Installation: The attaching lug nuts (1) must be re-tightened after the first 50 km. | |||
| |||
| Checking | ||
4 | Check tires for signs of damage and make sure that they are in good condition | If necessary, replace tires. | |
5 | Inspect condition of disk wheels (3), look for signs of damage, and check rim flanges are properly centered | If necessary, replace disk wheels (3). | |
6 | Check attaching lug nuts (1) and spherical spring washer (2) for damage | If necessary, replace attaching lug nuts (1) and spherical spring washer (2). | |
7 | Install in the reverse order |
Wheels