G35.25-3126-01
Shown on hub reduction gear of rear axle 747.570/571 | ||||
1 | Filling screw | |||
Shown on hub reduction gear of rear axle 747.572 | ||||
1 | Filling screw | |||
G35.25-3182-71
G35.25-3128-01
Shown on hub reduction gear of rear axle 747.580/590 | ||||
1 | Filling screw | |||
Shown on hub reduction gear of rear axle 747.582/584/593 | ||||
1 | Filling screw | |||
G35.25-3178-01
Rear axle differential |
3 | Filling screw |
G35.30-3133-01
| Check | ||
1 | Secure vehicle against rolling | The vehicle should be parked on a level, horizontal surface. | |
2 | Clean area around filling screws (1, 3) | ||
3 | Unscrew filling screw (3) from differential and check oil level | The oil level is correct when the lubricant reaches to the lower edge of the filler opening. Correct the oil level as indicated. | |
Axle drive (synthetic oil)Axle drive (synthetic oil) | |||
4 | Screw in filling screw (3) | Filling screw to differential | |
5 | Check the outside and inside of the wheel hubs for leaks | Small areas displaying a limited amount of seepage are not a cause for concern. Substantial leakage accompanied by continuous oil loss should be rectified immediately - write up on separate invoice. | |
6 | Remove filling screw (1) from hub reduction gear housing and check oil level | The oil level is correct if the oil is no more than 10 mm below the oil filler opening. Correct the oil level as indicated. | |
Hub drive (synthetic oil)Hub reduction gear (synthetic oil) | |||
7 | Screw in filling screw (1) | Filling screw to hub reduction gear |