Shown on model 460 |
1 | Master cylinder |
P29.00-2015-01
4 | Slave cylinder |
P29.00-2016-01
Shown on model 461.302 |
5 | Pressure transducer unit |
P29.00-2011-11
| Check | ||
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
1 | Raise vehicle with vehicle lift | ||
| |||
2 | Check both master cylinders (1) for leaks | Model 460, 461 with master cylinders | |
The dust boots must be tightly seated and must not be damaged. | |||
3 | Remove cover in right front fender | Model 463.204/207/220/221/224/225/227/304/307/324/325/327/328 | |
4 | Remove shields under pressure transducer unit (5) | If installed. | |
5 | Check pressure transducer unit (5) for leaks | Visual inspection. | |
6 | Check slave cylinder (4) on front and rear axle for leaks | Visual inspection. | |
7 | Check connector hoses | The connector hoses must not be cracked, spongy, swollen or chafed. They must be free of paint, grease and oil. | |
8 | Check lines and connections for leaks | The lines must not be pinched or chafed, or show signs of rust. | |
9 | Install shield plates under pressure transducer unit (5) | If installed. | |
10 | Install cover in right front fender | Model 463.204/207/220/221/224/225/227/304/307/324/325/327/328 | |
11 | Lower vehicle |