P27.00-2458-08
Shown on engine 651.9 in model 207.3 |
2 | Oil filter cover | 6 | Gray quick-release coupling | |
3 | Gray cable tie |
Shown on transmission 725.0 with drain screw (5) |
4e | Plug |
4k | Plug |
5 | Drain screw |
P27.00-2418-06
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Notes on automatic transmission | |||
| Check | ||
1 | Check whether the oil filter element is installed in the oil filter cover (2). | If a gray cable tie (3) is installed on the ferrule fitting of the oil line upstream of the gray quick-release coupling (6). | |
| |||
If the oil filter element has been removed, continue with operation step 2. | |||
If there is no gray cable tie (3) installed on the ferrule fitting of the oil line upstream of the gray quick-release fastener (6), | |||
| |||
Replace the oil filter element. | |||
Oil filter cover to oil filter housing | |||
Gray cable tie 3.5 x 150 mm | |||
| Remove | ||
2.1 | Remove center engine compartment lining. | Transmission 725.0 in model 218 with engine 276 | |
| |||
2.2 | Remove bottom sections of soundproofing. | Transmission 725.0 in model 207, 212, 218 with engine 642 | |
| |||
3 | Remove stop plug (4e). | ||
4 | Remove stop plug (4k). | If the torque converter cannot be turned via the drain opening of the stop plug (4e). | |
5 | Turn torque converter in direction of engine rotation until drain screw (5) appears in drain opening of stop plug (4e). | Commercially available devices/tools. | |
Drain off | |||
6 | Remove drain screw (5) and drain transmission oil from torque converter. | | |
Breather pipe | |||
| Remove | ||
7 | Remove automatic transmission oil pan with automatic transmission oil filters. | ||
| Model 207 with transmission 725.0 | ||
| Model 212, 218 with transmission 725.0 | ||
| |||
| Install | ||
8 | Install new automatic transmission oil pan with automatic transmission oil filters. | ||
| Transmission 725.0 in model 207 | ||
| Transmission 725.0 in model 212, 218 | ||
9 | Tighten new drain screw (5). | Drain screw to torque converter | |
| Clean | ||
10 | Clean torque converter and transmission bell housing in area of drain opening. | ||
| Install | ||
11 | Install stop plug (4e). | ||
12 | Install stop plug (4k). | If stop plug (4k) was removed beforehand. | |
Filling | |||
13 | Fill automatic transmission with oil. | ||
| Transmission 725.0 in model 207, 212, 218 | ||
| Install | ||
14.1 | Install center engine compartment lining. | Transmission 725.0 in model 218 with engine 276 | |
| |||
14.2 | Install bottom part of noise encapsulation. | Transmission 725.0 in model 207, 212, 218 with engine 642 | |
|
722 589 00 90 00
Breather pipe