D83.70-1568-09
1 | Bracket | 6 | Plug housing | |
2 | Antenna line | 7 | Contact receptacles | |
4 | Radio remote control transmitter. | 8 | Female contact | |
5 | Cable lug | A6/1 | Stationary heater radio remote control receiver |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
2.1 | Remove lower A-pillar trim on front passenger side. | Model 907.### 1#, 910.### 1# | |
| Model 907.### 1# | ||
| Model 910.### 1# | ||
2.2 | Remove lower A-pillar trim on driver's side. | Model 907.### 2#, 910.### 2# | |
| Model 907.### 2# | ||
| Model 910.### 2# | ||
3 | Remove vehicle tool kit carrier plate. | ||
| |||
4 | Remove lower trim for center instrument panel. | ||
| Model 907 | ||
| Model 910 | ||
5 | Remove instrument cluster. | ||
| |||
| Install | ||
6 | Retrofit stationary heater radio remote control receiver (A6/1) together with holder (1) and antenna line (2). | ||
7 | Prepare radio remote control wiring harness for retrofit. | ||
The electric lines for the radio remote control wiring harness are not included in the parts kit and must be fabricated. | |||
Use supplied contact sockets (7, 8), as well as cable lug (5) and plug housing (6). | |||
Wiring harness repair kit, basic | |||
8 | Retrofit radio remote control wiring harness. | ||
M6 | |||
9 | Install in the reverse sequence. | Operation steps 5 to 1. | |
10 | Enter special equipment into online vehicle data card. | Designation of the corresponding special equipment: Code HY1 (Radio remote control for auxiliary water heater). | |
In the tab "field organization texts" enter "Stationary heater radio remote control retrofitted according to document AN83.70-D-0002TS". | |||
11 | Perform SCN coding on automatic air conditioning control and operating unit (N22/2). | ||
| |||
Under the menu item "Adaptations Control units update", follow the instructions for "Updating SCN coding". | |||
Do not yet remove vehicle diagnosis system. | |||
12 | Teach in radio remote control transmitter (4) for stationary heater radio remote control receiver (A6/1). | To do this, select the following menu items: | |
Follow instructions from diagnostic system to teach in radio remote control transmitter (4). | |||
13 | Remove vehicle diagnosis system from vehicle. | ||
| |||
| Check | ||
14 | Carry out function test of stationary heater radio remote control. | To do so, press "ON" button on radio remote control transmitter (4) until the "ON" message appears in the display of the radio remote control transmitter (4) and the vehicle's ventilation audibly switches on. The hot-water auxiliary heater is switched on. |
000 589 13 99 00
Wiring harness repair kit, basic