MODEL | 374.502/523/551/554/557/584 with BODY 374.860 |
MODEL | 374.602/651/655/682/685 with BODY 374.870 |
MODEL | 374.607/691/695, 940.1/2/3, 942.1/3, 943.1/3, 944.0/1/2 with BODY 944.890 |
MODEL | 375.1 with BODY 375.830 |
MODEL | 375.1 with BODY 375.850 |
MODEL | 375.3 with BODY 375.810 |
MODEL | 375.3 with BODY 375.820 |
MODEL | 375.4 with BODY 375.860 |
MODEL | 950.5/6, 952.5/6, 953.6, 954.5 with BODY 940.890 |
MODEL | 950.5/6, 952.5/6, 953.6, 954.5 with BODY 940.899 |
MODEL | 970, 972, 974, 975, 976 with BODY 972.899 |
MODEL | 970.0/2/3, 972.0/3, 974.2, 975.0/2, 976.0/3 with BODY 972.890 |
Shown on body 972.899 |
1 | Seal |
2 | Window |
3 | Screwdriver |
4 | Cup suction tool |
W67.20-0001-06
W67.20-0002-09
Shown on body 972.899 |
1 | Seal | 6 | Window imprint | A | Overlap area of pulling cord | ||
2 | Window | 7 | Rear panel | ||||
5 | Pulling cord | 8 | Rear wall paneling |
| Remove | ||
1 | Release bunk and fold down | Only on vehicles with bunk. | |
2 | Install cup suction tool (4) on inside of window (2) | ||
3 | Pry sealing rubber lip (1) from vehicle interior over edge of window frame toward outside with screwdriver (3) | Hold window (2) with cup suction tool (4). | |
4 | Remove window (2) with cup suction tool (4) | ||
5 | Remove seal (1) from window (2) | ||
| Install | ||
6 | Install seal (1) on edge of window (2) | Pull long, angled sealing lip on gasket (1) up to passenger compartment. The window imprint (6) should be located at the bottom of the window (2) after installation. | |
7 | Insert pull-in cord (5) all the way around the window (2) below the long rubber lip on the seal (1) | The overlap area of the pulling cord (A) should be at the bottom and approx. 10 cm long. | |
8 | Coat angled side of seal (1) with lubricant | Lubricant | |
9 | Press window (2) uniformly against window frame from rear wall (7) with aid of helper with rubber seal (1) installed | Allow ends of pull-in cord (5) to hang down into vehicle interior. | |
10 | Uniformly pull ends of pull-in cord (5) into vehicle interior | The long sealing rubber lip (1) should be positioned uniformly over the rear wall paneling (8) all the way around. | |
11 | Check whether seal (1) is seated correctly, correct if necessary | ||
12 | Remove lubricant residues from window (2) and seal (1) | ||
13 | Fold up bunk and secure | Only on vehicles with bunk. |