Test values for gaps on hoods, doors and lids
Number | Designation | Model 211.2 | |||
BE60.00-P-1001-01F | Size of gap | Engine hood/fender | Dimension"A" | mm | 3.5 (0.5) |
Engine hood/headlamp | Dimension" B" | mm | 4 (0.5) | ||
Radiator grille/bumper | Dimension "C" | mm | 5.5 (1) | ||
Fig. see | |||||
BE60.00-P-1002-01F | Size of gap | Front door/A-pillar | Dimension "D" | mm | 4.5(-0.5/+1) |
Front door/fender | Dimension" E" | mm | 4 (-0.5/+1) | ||
Front door/rear door | Dimension" F" | mm | 4 (-0.5/+1) | ||
Front door/roof | Dimension" G" | mm | 4.5(-0.5/+1) | ||
Rear door/top side section | Dimension "H" | mm | - | ||
Rear door/bottom side section | Dimension" I" | mm | 3.5 (-0.5/+1) | ||
Fig. see | |||||
BE60.00-P-1003-01F | Size of gap | Trunk lid/top of rear fender | Dimension" J" | mm | - |
Trunk lid/taillamp | Dimension" K" | mm | - | ||
Trunk lid/bumper | Dimension "L" | mm | - | ||
Rear fender/taillamp | Dimension" M" | mm | 2.5 (1) | ||
Trunk lid cover/taillamp | Dimension "N" | mm | - | ||
Fig. see | |||||
BE60.00-P-1004-01F | Size of gap | Tank flap | Dimension "O" | mm | 3.5 (0.5) |
Fig. see | |||||
BE60.00-P-1005-01F | Size of gap | Tailgate spoiler/roof | Dimension "P" | mm | 7(-0.5/+1) |
Tailgate/rear fender | Dimension" Q" | mm | 4.5 (1) | ||
Taillamp in tailgate/taillamp | Dimension" R" | mm | 5 (1) | ||
Tailgate/bumper | Dimension "S" | mm | 6 (1.5) | ||
Rear window/D-pillar | Dimension "T" | mm | 4.5 (1) | ||
Rear door/roof | Dimension" U" | mm | 4.5(-0.5/+1) | ||
Fig. see | |||||
Feeler gage
129 589 03 21 00
P60.00-2250-06
Adjust hoods, doors and lids as shown in drawing. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2251-06