Check values for gaps
Number | Designation | Model | Model | |||
BE60.00-P-1001-01T | Gap dimension | Engine hood to fender | Dimension "A" | mm | 3.5 (0.5) | 3.5 (0.5) |
Engine hood to headlamp | Dimension "B" | mm | 3.5 (0.5) | 3.5 (0.5) | ||
Engine hood to A-pillar | Dimension "D" | mm | 4.0 (0.5) | 4.0 (0.5) | ||
Radiator grille/bumper | Dimension "C" | mm | 5.0 (1.0) | 2.0 (1.0) | ||
Engine hood to bumper | Dimension "P" | mm | 5.0 (1.0) | 5.0 (1.0) | ||
Bumper to headlamp | Dimension "Q" | mm | 3.5 (0.5) | 3.5 (0.5) | ||
See picture | ||||||
BE60.00-P-1002-01T | Gap dimension | Front door to fender | Dimension "E" | mm | 4.0 (0.5) | 4.0 (0.5) |
Front door to rear fender | Dimension "F" | mm | 4.0 (0.5) | 4.0 (0.5) | ||
Front fender to A-pillar | Dimension "G" | mm | 3.5 (0.5) | 3.5 (0.5) | ||
Front fender to headlamp | Dimension "H" | mm | 3.5 (0.5) | 3.5 (0.5) | ||
See picture | ||||||
BE60.00-P-1003-01T | Gap dimension | Trunk lid to rear fender, top | Dimension "J" | mm | 3.5 (0.8) | 3.5 (0.8) |
Trunk lid to rear lamp unit | Dimension "K" | mm | 3.5 (0.8) | 3.5 (0.8) | ||
Trunk lid to bumper | Dimension "L" | mm | 5,5 (1.5) | 5,5 (1.5) | ||
Rear fender to rear lamp unit | Dimension "M" | mm | 2.5 (0.5) | 2.5 (0.5) | ||
See picture | ||||||
BE60.00-P-1004-01T | Gap dimension | Fuel filler flap | Dimension "O" | mm | 3.0 (0.5) | 3.0 (0.5) |
See picture | ||||||
Feeler gauge
129 589 03 21 00
P60.00-2758-06
1 Check gaps on hoods, doors and covers.
The corresponding gap dimension should not run wedge-shaped or be too narrow at points. The gap dimension should not deviate from parallel over or below the specified tolerance range. If the inside clearance of body gaps is too large or too small, the hang-on parts must be centered accordingly.
P60.00-2759-06